Skoda Superb (2010) mit Radio Swing - iPod / iPhone Schnittstelle und USB-Anschluss nachrüsten
Instructions for installing a box for connecting USB sticks, SD cards, AUX-In and with a Bluetooth hands-free system. You can retrofit all Streaming Boxes in a comparable way.
Vehicle is a Skoda Superb.
In this example, a Radio Swing (2010) is used. These instructions can also serve as a template for retrofitting other radio models, e.g. Dance, Cruise PN1, Beat, and much more.
Skoda Superb - Swing radio - Remove the cover
Carefully lever off the cover of the radio with a small rod from the inside or with a removal tool (see online shop, accessories area) from the outside.
Skoda Superb - Swing radio - remove radio
Loosen the screws in order to be able to pull out the radio (see arrows).
Skoda Superb - Swing radio - Pull out the radio
Carefully pull out the radio a little and disconnect the connector.
Also disconnect the plug from the warning lamp for the passenger airbag - attention, from now on please do not switch on the ignition, otherwise there will be a fault in the airbag system!)
Skoda Superb - Swing radio - Loosen the radio antenna
Loosen the antenna connector (push it backwards approx. 3mm)
Skoda Superb - Swing radio - lay the wiring harness
Route the wiring harness from the interface in the passenger footwell towards the radio slot. In case of doubt, a wire is suitable for this, in order to be able to carry it through better.
Skoda Superb - Swing radio - connect interface
Then you can take the plug from the radio slot.
Skoda Superb - Swing radio - integrate wiring harness
Integrate the wiring harness (remove the blue original connector from the Quadlock connector block and loop it through the wiring harness of the interface). Then insert the white plug of the interface in the position where the blue plug was previously in the radio.
Skoda Superb - Swing radio - Fasten the ground point
Fasten the ground point of the wiring harness - here on a screw in the rear of the radio slot. Alternatively, the earth cable can also be attached to the radio housing (using an appropriate screw).
Skoda Superb - Swing radio - lay microphone
In this example, the microphone is attached in the area of the ignition key. This method is very simple and does not require a lot of effort to position it. You can get to the position directly from the radio slot.
The cable can then be led to the interface in reverse order.
Skoda Superb - Swing radio - connect interface
Now the interface (stowed here in the storage net of the passenger footwell) can be connected to the cable harness and the microphone and equipped with a USB stick or SD card.
Then insert the radio again, plug in the Quadlock connector, antenna and airbag control lamp. Tighten the screws and clip in the radio panal.
FINISHED.
ATTENTION: Before installing the radio, please test all functions of the interface / streaming box. If everything works, you can go to complete the assembly.
These installation example instructions are only intended as a model for the installation mentioned. In principle, no liability is accepted.
Errors or problems of any kind cannot be ruled out. We are happy to be at your disposal during the installation. faq@usb-nachruesten.de